4 in 1 Electronic Wall Stud Finder with LCD Display for Wood AC Wire Metal Studs

Description: Product DescriptionWhether you’re hanging a picture,mounting a TV,renovating part of your home, or working as a professional contractor, you need to know what is on the other side .Tavool stud finder is one of those tools that you will eventually need. Tavool stud finder can be the difference between a successful DIY home project and a bad one.This wall detector features large LCD display, ergonomic design and multi-sense technology for accurate detection of both metal and wooden studs. It will also detect live wiring up to two inches into walls. The 4 scanning modes (stud scan, deep scan, metal scan and AC scan) make it ideal for both tradesmen and home carpenters. With this device, you can immediately find a suitable place on the wall without making any extra holes.Tavool stud scanner beam finder is a device that is used to determine exact location of framing studs that are located behind the drywall. This Multi-scanner stud finder uses electronic signals to quickly locate edges and center of metal, studs, joists, pipes, live AC wire behind walls, floors and ceilings.The cost of a stud finder wall scanner will almost always be less than the cost of repairing the damage done from not locating one before hanging something. TAKE IT HOME AND START YOUR PROJECT !Note: This stud finder can quickly locate metal, studs, joists, pipes, live AC wire behind all kinds of walls floors and ceilings but except the cement board wall and brick wall, you can use it on popcorn ceilings, plaster walls, textured surfaces, drywall, etc.Stud Scan DetectionDeep Scan scans through 2 layers of drywall up to 1.5 in.(38 mm) deep. DeepScan Mode is a higher sensitivity scanning mode that should be used when there are extra layers of wallboard or paneling.To minimize false readings or find objects further behind the wall that may not be a stud,please always start your scan in Stud Scan first.Metal Scan DetectionSince Tavool stud finders are looking for change in density behind drywall, not a particular material, in StudScan and DeepScan Modes the detector will react to metal studs the same as it would for wooden studs.After you find center of a object, Please Use Metal Scan to determine if the previous reading in Stud scan was a wood stud, or metal stud/pipe.Live AC Wire DetectionAC Wire detection indicates the presence of live, unshielded electrical wiring up to 2 inches (51 mm) deep. In all modes, this wall scanner always detect and indicate Live AC Wires.Note: AC Wire Detection works in both StudScan / DeepScan / MetalScan Modes. The AC Wire Detection Icon will flash when live, unshielded wires are detected.Step 1:Calibrate the tool before every scanAfter choose the mode, press and hold the scan button( on the side of the tool) to calibrate it. Wait until the reducing bars disappear and short beep sound,then calibration has completed.In stud/deep mode, place the tool against the wall to calibrate it; In AC/Metal mode, make sure put the tool in the air to calibrate it.Step 2: Scan the wallMove it gently along the wall and please keep moving the tool in the same direction.If shake or lift the scanner accidentally, the device needs to be re-calibrated.The narrow on the screen together with the beep signal, would indicate the location of the stud.Step 3: Find the location of the studWhen the signal bar is full and the beep alarm is loudest, you find the center of an object. Mark it with your pencil.Then switch to Metal Scan mode to confirm whether it is a metal. If not, it means that you found the center of a stud. (More details refer to the above description of "Metal Scan Detection")Then you can drill to hang things

Price: 14.95 USD

Location: Walnut, California

End Time: 2024-10-16T00:52:25.000Z

Shipping Cost: 0 USD